JB/T 8010.17-1999 Self-adjusting clamping plate for machine tool fixture parts and components
Basic Information
Standard ID:
JB/T 8010.17-1999
Standard Name: Self-adjusting clamping plate for machine tool fixture parts and components
Chinese Name:
机床夹具零件及部件 自调式压板
Standard category:Machinery Industry Standard (JB)
state:in force
Date of Release1999-08-06
Date of Implementation:2000-01-01
standard classification number
Standard ICS number:General, Terminology, Standardization, Documentation>>Vocabulary>>01.040.29 Electrical Engineering (Vocabulary)
Standard Classification Number:Machinery>>Process Equipment>>J44 General Fixture
Publication information
other information
Focal point unit:Mechanical Science Research Institute
Publishing department:Mechanical Science Research Institute
Introduction to standards:
JB/T 8010.17-1999 This standard specifies self-adjusting clamps with an adjustment range of 0~200mm. This standard was first published in 1983 as JB 3408-83 and revised for the first time in 1991 as GB/T 12872-91. JB/T 8010.17-1999 Self-adjusting clamps for machine tool fixture parts and components JB/T8010.17-1999 Standard download decompression password: www.bzxz.net
Some standard content:
ICS 25. 080. 01
Standard of the Machinery Industry of the People's Republic of China
Parts and units of jigs and fixtures
The parts and units of jigs and fixtures1999-08-06 Issued
State Machinery Industry Bureau
Implementation on 2000-01-01
Standard of the Machinery Industry of the People's Republic of China
Parts and units of jigs and fixtures
Self-regulating pressure plate
The parts and units of jigs and fixturesSelf-regulating pressure plate This standard specifies the self-regulating pressure plate with an adjustment range of 0~200mm. 2
Cited Standards
JB/T8010.17-1999
The provisions contained in the following standards constitute the provisions of this standard through reference in this standard. When this standard was published, the versions shown were valid. All standards are subject to revision, and parties using this standard should explore the possibility of using the latest version of the following standards. GB/T898—1988
JB/T 8004.1—1999
JB/T8004.11—1999
3 Dimensions
Dimensions are shown in the following figure and table.
4 Marking
4.1 Marking example:
Stud b=1.25dwww.bzxz.net
Machine tool fixture parts and components Shouldered hexagonal nut Machine tool fixture parts and components T-slot nut Adjustment range of 0~70mm Self-adjusting pressure plate: Pressure plate 0~70JB/T8010.17—1999
Approved by the State Machinery Industry Bureau on 1999-08-06 and implemented on 2000-01-01
Adjustment range
0 ~200
JB/T 8004.
JB/T8010.171999
Note: The length of the double-headed stud can be selected according to its adjustment range, according to GB/T898 115
JB/T 8004.1
GB/T898
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.