JB/T 7384.15-1994 Fasteners - Ring gauge for gap and misalignment between cotter pin legs
Basic Information
Standard ID:
JB/T 7384.15-1994
Standard Name: Fasteners - Ring gauge for gap and misalignment between cotter pin legs
Chinese Name:
紧固件 检测开口销两脚的间隙和错移量环规
Standard category:Machinery Industry Standard (JB)
state:in force
Date of Release1994-07-26
Date of Implementation:1995-07-01
standard classification number
Standard Classification Number:Machinery>>General Parts>>J13 Fasteners
associated standards
Publication information
publishing house:Mechanical Industry Press
Publication date:1995-06-01
other information
Drafting unit:Machinery Standardization Research Institute of the Ministry of Machinery Industry
Focal point unit:National Technical Committee for Fastener Standardization
Proposing unit:National Technical Committee for Fastener Standardization
Publishing department:Ministry of Machinery Industry of the People's Republic of China
Introduction to standards:
This standard specifies the type and size of the ring gauge for detecting the gap and misalignment between the two legs of the split pin. This standard applies to item 16 in the table of ZB J13 002.5. JB/T 7384.15-1994 Fasteners Testing the Gap and Misalignment Ring Gauge for Split Pins JB/T7384.15-1994 Standard download decompression password: www.bzxz.net
Some standard content:
Mechanical Industry Standard of the People's Republic of China
JB/T7384.1～7384.18-94
Special Inspection Fixture for Fasteners
Published on 1994-07-26
Ministry of Machinery Industry of the People's Republic of China
Implemented on 1995-07-01
Mechanical Industry Standard of the People's Republic of China
Fasteners
Detecting the Gap and Misalignment of the Two Legs of Split Pins Subject Content and Scope of Application
This standard specifies the type and size of the ring gauge for detecting the gap and misalignment of the two legs of the split pins. This standard applies to item 16 in the table of ZBJ13002.5. Reference standards
GB1957
Split pin
Smooth limit gauge
ZBJ13002.5 Purple hardware test method Pin size and geometric accuracy Type and size
The type and size of the split pin ring gauge are shown in Figure 1 and Table 1. Table 1
d Nominal
Limit deviation
—0. 011
Approved by the Ministry of Machinery Industry on July 26, 1994
JB/T7384.15-94bzxZ.net
—0.0235
—0.0275
Implemented on July 1, 1995
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.